一、新機啟動前注意事項（ Precautions before starting a new machine）

     1.   加注機油

        Add oil

     2.   加注適量汽油，并觀察有無漏油

        Fill a proper amount of gasoline and observe whether there is oil leakage

     3.   確認油路是否通暢，化油器放油（油箱蓋緊，油孔是否堵，濾杯是否過油，油管有無變形，油開關是否打開）

        Confirm whether the oil circuit is smooth and the carburetor is drained (the oil tank cap is tight, whether the oil hole is blocked, whether the filter cup is overfilled, whether the oil pipe is deformed, and whether the oil switch is open)

     4.   各操作把手在相應安全位置 （主變速在空擋，插秧離合器在固定，主離合在離）

       Each operating handle is in the corresponding safe position (the main gear shift is in neutral, the transplanting clutch is fixed, and the main clutch is disengaged)

     5.   確認周圍安全，啟動機器

       Confirm the surrounding safety and start the machine

二、裝載苗的注意事項（Precautions for loading seedlings）

     1.   挑選較好的苗（苗發育不好，秧針就取不到苗，就會缺苗）

        Select better seedlings (if the seedlings are not well developed, the needles will not get the seedlings, and there will be a shortage of seedlings)

     2.   秧板移到一側

        Move the seedling board to one side

     3.   從中間往兩側開始下苗

        Start from the middle to both sides

     4.   放盤時，苗尖向上

        When releasing, the seedling tip shall be upward

     5.   手動送秧把手將苗送整齊，不能用手推苗

        Send the seedlings neatly with the manual handle, and do not push the seedlings by hand

     6.   往秧板與苗之間澆水

        Watering between seedling boards and seedlings

     7.   皮帶現出一半續盤

        Belt shows half of the extension plate

      三、發動機速度不穩（喘氣，發動機跳繩）（Unstable engine speed (gasping, engine skipping)）

     1.   有無汽油，油質

       Whether there is gasoline and check the oil quality

     2.   化油器:先導螺栓(油氣混合比和啟動噴油嘴）和主進油孔堵

       Carburetor: pilot bolt (oil gas mixture ratio and starting fuel injection nozzle) and main oil inlet plug

     3.   油路不暢（油少，油不好，濾杯不過油，油箱蓋過緊，油格攔,油管抱箍過緊）

       The oil circuit is not smooth (there is little oil, the oil is not good, the filter bowl is not full of oil, the oil tank cover is too tight, the oil grid is blocked, and the oil pipe hoop is too tight)

     4.   連接桿上張緊彈簧脫落

       The tension spring on the connecting rod falls off

5.   海綿被浸濕

        Sponge is soaked

四、秧爪不動（The seedling claw does not move）

     1.   株距擋沒撥到位

        The spacing block is not in place

     2.   株距齒輪是否完好

        Whether the pitch gear is intact

     3.   46沒調好

        46 Not adjusted properly

     4.   秧門口有異物：或其他（橫向送秧齒損壞，左右箱體，中間箱體）

        There are foreign matters at the gate of the rice seedling: or others (lateral rice seedling feeding teeth are damaged, left and right boxes, and middle boxes)

五、缺秧（Lack of seedlings）

苗不好，苗盤發育不好，缺苗；苗盤過窄；

    Poor seedlings, poor seedling development, and lack of seedlings; The seedling bottom is too narrow;

下苗不暢：壓秧桿太緊，苗土厚，苗太干，苗太濕，苗土薄，縱向不送秧，苗盤過寬，續盤不好

    Poor seedling lowering: the seedling pressing rod is too tight, the seedling soil is thick, the seedling is too dry, the seedling is too wet, the seedling soil is thin, the seedling is not sent longitudinally, the seedling plate is too wide, and the continuation plate is not good

苗盤過窄

    The seedling tray is too narrow

秧針損壞：磨損，斷裂

    Damaged rice needles: worn and broken